Temperature Control Module with External Measuring Cable, Panel Mount Layout and Output Switching for Automation Use Multicolor

Features: Probe Temperature Reading: The external probe checks heat levels at the measured point, helping connected equipment reacts automatically instead of relying on manual checks or repeated switching. Adjustable Limit Setup: Set upper and lower thresholds to suit project needs, then let the output circuit guide cooling equipment or other connected devices with consistent response. Panel Ready Housing: Flush mount construction, side clips, and screw terminal connections support a clean equipment cabinet install while keeping wiring access straightforward during setup. Stored Setting Support: Delay start helps reduce frequent cycling, while parameter memory and guard functions keep preferred values available after power loss or routine service. Practicality: It can be used for the temperature adjustment of household equipment, the matching of intelligent control systems, the temperature control management of small automatic equipment, and it is suitable for people who need temperature monitor and temperature control. Specifications: Component: ABS Size: Approx.7.50x7.50x3.45cm/2.95x2.95x1.36inch Voltage: 12-100V / 110V / 220V Temperature Display: Default High Temp -20 to 300℃; Low Temp Mode Adjustable To -20 to 120℃ Operating Temperature: -10 to 60℃ Output Capacity: Normally Open 16A/250VAC Opening Size: Approx.7.10x2.90cm/2.80x1.14inch Package Includes: 1 Set Temperature Controller note: 1.Please allow 1-2cm errors due to manual measurement, make sure that you donot mind before you order. 2.Due to the differences between different monitors, the picture may not reflect the actual color of the item.