Remote Home controller 110V 240V 30A Relay Wireless RF Smart Remote Control Switch Transmitterand Receiver 433MHz Specifications: Remote control Transmitter: Operating voltage: DC12V (23A or 12V battery x1) Transmitting frequency: 433MHz Encoding Type: Fixed code Receiver sensitivity: > -105dB Transmission distance: 100M (Open field) Size: approx 55x28x10mm Receiver board: Operating voltage: AC 110V - 240V Output voltage = Operating voltage Operating frequency: 433MHz(Same with Remote control) Encoding Type: learning code(you can buy extra 315MHz remote controllers for this receiver) Rated contact current of relay: 15A or 240VAC, 15A or 110VAC (Please notice that: Although the relay is marked 30A 240VAC. The 30A is for the peak current of your load. The rated current of your load should be less than 15A) Box size: approx 65 x 45 x 28mm How to clone: Self-locking: controlled by a key, press on and off again Interlock: remote control has 2 keys, one key on, and one key off Inching: remote control with a button, press and hold the button of the remote control, and the relay is sucked in Release the key relay of the remote control and disconnect Click: The controller is connected to the power, press the learning button on the side of the controller once, and the indicator light is in the learning state, then press any button on the remote control, and the indicator light flashes 3 times continuously, indicating the completion of learning. Self-locking: The controller is connected to the power, press the learning button on the side of the controller 2 times, and the indicator light is in the learning state. Then press any button on the remote control, and the indicator light flashes for 3 times continuously, indicating the completion of learning. Interlock: Turn ON the power of the controller, press the learning button ON the side of the controller 3 times and the indicator light is in the learning state. Then press the ON button on the remote control. After waiting for 3 seconds, press the OFF button key of the remote control to indicate the completion of learning. Clear code: The controller is connected to the power, and press the learning button on the side of the controller 8 times continuously. Package Includes: 1 x Wireless receiver 1 x 2 button remote control transmitter Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.