1、The wind pressure transmitter adopts imported sensor chip, which is finely assembled. 2、The use of advanced circuit designed and temperature compensation technology makes the transmitter performance more superior and the measurement more stable and accurate. 3、The product enhances its anti‑interference ability and helps extend its service life. 4、The wind differential pressure sensor is assembled with OEM silicon piezoresistive differential core, and the shell is aluminum alloy structure. 5、The two pressure ports are M10 thread and cock ditch, which can be directly installed on the measuring pipe or connected by pressure pipe. 6、Widely used in boiler air supply, down ventilation and other power, pressure process control fields in the coal industry. 1 x Wind Pressure Transmitter Item Type: Wind Pressure TransmitterMaterial: Aluminum alloyColor: Yellow (with digital display)Voltage: DC24VOptional Measuring Range: 0.1Kpa. 0.2Kpa. 0.3Kpa. 0.4Kpa. 0.5KpaAccuracy Level: 0.2Compensation Temperature: 0-50℃Ambient Temperature: -30-80℃Working Method: Differential pressureZero Temperature Drift: ± 0.03%FS/CSensitivity Temperature: ± 0.03%FS/COverload Pressure: 300%FSThe Pressure Interface: M10 threadDebugging Method: Open The HSM Connector, Unscrew The Stainless Steel Tube, You Can see the Zero and full range resistors, external standard power supply and ammeter (above 0.2), you can adjust the steps as follows: When the transmitter is not pressurized, adjust the Zero-point resistor to make the output current 4mA;The transmitter is pressurized to the full scale, and the full scale resistor is adjusted to make the output current 20mA;Repeat the above steps two or three times until the signal is normal.After adjustment, tighten the protective coverSize: Approx. 85mm / 3.3in35mm / 1.4in120mm / 4.7in8mm / 0.3in22mm / 0.9in37mm / 1.5in32mm / 1.3in 3.7mm / 0.1in58mm / 2.3in70mm / 2.8in