The anti-dew heater strip is used for anti-dew on front window of cooled cameras. This kit includes zip-tie, anti-dew heater strip and an Y power cord:The thickness of anti-dew heater strip is 0.2~0.3mm. The "Y" power cord is designed to connect in-line with cooler power supply for convenience. We recommend a DC adapter giving 12V at 0.35 A resulting in a heating power on strip that is around 4.2 . You can use one and same power cord to power both fan and heater simultaneously, but make sure not to exceed recommended amount of Ampere. NOTE: for many cameras a heater strip is not necessary since they have one that is built into cameras themselves. ASI071MC-P/ASI6200/ASI2600/ASI2400 cameras come with an anti-dew heater that heat protective glass to avoid any dew problems. For ASI183/ASI1600/ASI294/ASI533 cameras, the heat emitting from TEC be conducted to camera case and avoid any dew problems when TEC cooling system is working. How to use it? 1. Tear out protective film on adhesive tape 2. Put anti-dew heater strip on front facing of camera and make sure black cable is in right position (lining next to DC plug at rear end) 3. Tie black cable with a zip tie on camera body.4. Plug in power cord, then everything is done. 4. Plug in power cord, then everything is done. Now you should be dew-free while with camera. NOTICE: Be careful about welding portion, it is vulnerable can not hold very strong pull. Color: As Shown Material: plastic Package Contents: 1 * Heater Strip set Only above package content, other products are not included. Note: Light reflection and different displays may cause color of item in picture a little different from real thing. The measurement allowed error is +/- 1-3cm.