Major Applications: Traffic Monitoring, Obstacle detection, Level measurement, Smart device, Security and obstacle avoidance, Drone altitude holding and terrain following, Machine control and safety sensors, Distance measuring instrument TFmini-S is the improved version of TFmini, it is a single-point micro-type ranging module and could be widely used in the integrated application of drones, UAVs, Robots and industrial equipments. It is based on ToF (Time of Flight) principle and integrated with unique optical and electrical , so as to achieve stable, precise, high sensitivity and high-speed distance detection. Communication interface:UART/I2C Electromagnetic Compatibility(EMC):EN 55032 Class B Operating Range:0.1-12m Maximum operating range at 10% reflectivity:5m Applicable voltage range:4.5-6V Average power consumption:0.12W FOV:2 Baud rate:115200 Data bit:8 Stop bit:1 Parity bit:0 Minimum resolution ratio:5mm Frequency:100Hz(1-1000Hz adjustable) Light source:VCSEL Wavelength:850nm Operating temperature:20-60 Light sensitivity:70,000lux Accuracy:1% (less than 6m),2% (6m-12m) Size:42mmx15mmx16mm Weight:6.1g FAQ Q1: Is TFmini-S available with 3.3V or other power supply voltage? A1: Sorry, it is for the time being. The Standard power supply of TFmini-S is 5V0.1V. Q2: TFmini-S heat up after operating for a while. Is it broken? A2: This is the normal operating condition of the product. The temperature of the chip and circuit board slightly up after a continuous operation, which is a normal case. Q3: Can TFmini-S be connected with for or for for use? A3: Yes, it can. TFmini-S adopts serial communication protocol so that it can connect to any control board supporting serial port communication. Due to different product batches, the appearance , which does not affect the use. Colour:As Shown Material:PC Package Contents: 1 * TFmini-S Lidar Single-Point Micro-type Ranging Finder Module 2 * Cable Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.