Compatibility: Replacement strip compatible with Festool 495209 and 495207 splinter guards. Fits Festool FS/2, FS/2 KP, FSK guide rails, and Festool rail saws. Regular replacement helps maintain splinter-free cuts, especially when switching between saws or using the guide rail with multiple tools. Function: Replace the splinter guard as needed to ensure accurate alignment of the guide rail with the cutting line and prevent tearing during parallel and lateral cuts. The new splinter guard aligns precisely with the saw blade, improves cutting accuracy, and reduces setup time. Clear design enhances visibility of the cutting line. High-quality: Made from high-quality soft rubber with strong adhesive backing. Features high transparency and strong adhesion for secure attachment to the guide rail without peeling off easily. Easy to replace: The splinter guard is cut during first use, reflecting the exact cutting edge for precise placement at the scribe mark. Simply remove the protective tape before application. Note: Clean the guide rail thoroughly with acetone and ensure the surface is free of grease before installing the new splinter guard. Additional Notes: - Apply on a clean surface to avoid dust or debris adhering to the adhesive. - Peel off the adhesive strip carefully to prevent trapping debris. - Use a scraper and acetone to remove any residual adhesive before installation. - When reapplying, position the guard slightly outward to allow for clean cutting. Color: As shown in photo Material: Plastic Package Contents: 1 x Splinter Guard Replacement Strip Note: - Allow 1-3 mm measurement tolerance due to manual measuring and 1-3 g weight variation. - Actual color may vary slightly due to lighting conditions and monitor display differences.