RP2350-LCD-1.28 is a low-cost, high-performance MCU board. Tiny size with onboard 1.28inch LCD round display, Li-ion battery recharge manager, 6-axis sensor (3-axis accelerometer and 3-axis gyroscope) and so on, adapting all GPIO and Debug pins, which makes it easy for you to develop and integrate it into products quickly. RP2350 microcontroller chip designed by for Raspberry Pi. Adopts unique dual-core and dual-architecture design: dual-core Arm Cortex-M33 processor and dual-core Hazard3 RISC-V processor, flexible clock running up to 150 MHz 520KB of SRAM, and 4MB of onboard Flash memory Type-C connector, keeps it up to date, easier to use Onboard 1.28inch 240x240 pixels 65K colorful IPS LCD display for clear color pictures Lithium battery recharge or discharge header, suitable for mobile devices All GPIO pins are adapted through 1.27 pitch female headers (There are 30 pins in total, but some pins have been connected to the internal circuit,) USB 1.1 with device and host support Low-power sleep and dormant modes Drag-and-drop programming using mass storage over USB 2 x SPI, 2 x I2C, 2 x UART, 4 x 12-bit ADC, 24 x controllable PWM channels Temperature sensor 12 x Programmable I or O (PIO) state machines for custom peripheral support Colour:BlackandBlue Material:PCBandPlastic Package Contents: 1 x Development Board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is 1-3cm.