1. :(1080(4),1120(5),1160(6),1200(7),1240(8),1280(9),1320(H),1360(C),1258(D)MHz) 2. Button control and 0.96 TFT LCD display 3. 5V 1A DC IN 4. Connector: SMA 5. Compatible With for Fatshark Goggles , Goggles, Goggles V1 V2(if used for Goggles, it Need to be used in conjunction with 5.8G RX PORT module) Settings manual mode, increase the frequency up and decrease it down down vertically to enter the menu 1. Automatic search, down vertically to enter submenu - Auto1, Auto 2 (dial up or down to switch modes, down vertically to confirm), go left or right to return to the previous menu 2. RSSI, down vertically to enter the submenu - RSSI calibration, RSSI output - off, dial up or down to switch If RSSI calibration is , down vertically to enter the RSSI calibration submenu, and down vertically to start calibration. 2. If RSSI output - off is , down vertically to enter RSSI output or turn off RSSI submenu, switch up and down, and down vertically to confirm. Return to the previous menu by turning left or right. 3. Receiver mode setting, automatic, switch between receiver A and receiver B by dialing up or down Return to the previous menu by turning left or right. 4. Save and exit, down vertically to return to the frequency and RSSI display interface. After pressing save and exit, the changed settings take effect. Power off save the last manually or automatically adjusted frequency. Color: As Shown Material: Plastic+Metal Package Contents: 1 x Receiver set Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.