Feature: 1. Fast preheating: Motorcycle heating pads are heated quickly, with a heating pad, you will quickly feel warm while riding. 2. Temperature control: Built-in intelligent temperature control chip, five-speed adjustable temperature, more convenient to use. 3. Excellent Performance: Heated grip handlebar with IP67 waterproof, abrasion resistant, tear resistant, anti-aging, alkali resistance. 4. Easy installation: The heating part is fixed by straps, convenient and quick to install, and does not damage the handlebar. 5. Widely Used: Heated grips heating pad widely used for most 12V motorcycles, ATVs, scooters, etc. Specification: Item Type: Motorcycle Handlebar Heating Pad Material: Fabric: Pure PVC; Bandage: polypropylene; Heating sheet: composite fiber heating wire Input voltage: DC12V Working voltage: DC 12.2V(Because this product has anti-loss protection, lower than 12.2V, the product cannot be used) Operating temperature : -30C - +100C Power and temperature control values: First speed (red): 18W/85C; Second speed (orange): 14W/75C; Third gear (yellow): 10W/60C; Fourth gear (green): 8W/55C; Fifth gear (blue): 6W/50C (The above data is obtained from experience, the specific value or due to the change of voltage, environment and other objective factors fluctuate slightly, for reference only) Strip Fuse: 5A Package List: 2 x Motorcycle Handlebar Heating Pad 1 x Adhesive 5 x Cable Ties 2 x Jumper Wire 1 x Bracket 1 x Connection Line 1 x Instructions Note: (1) Please select appropriate equipment according to the ambient temperature. Under low temperature conditions, if the temperature of the electric handle sleeve cannot be detected in time and accurately due to numbness and numbness of the hand, please use low gear first or medium to avoid high temperature burns. (2) This product is only suitable for motorcycles with 12V battery. Please confirm your car voltage and read the installation diagram carefully before installation. Incorrect voltage and wiring mode will damage parts. (3) This product can only be installed on the use of motorcycle handle power supply, before the installation can first use a battery to test whether the product is properly powered.(4) It is strictly prohibited to work with electricity (idle burning) when not riding, to avoid excessive temperature of the electric handle sleeve from damaging the original handle. (5) Wiring is recommended to connect the electric door lock. cable. Most models have a black positive pole and a green negative pole. In special cases, it is recommended to use a multimeter to measure.