Models and specifications 1.01 — 1/8 BSP (DN6) male thread. Thread diameter: 9.7 mm. 2.02 — 1/4 BSP (DN8) male thread. Thread diameter: 12.7 mm. Key benefits Precise, standard BSP sizing: clearly labeled DN6 and DN8 equivalents make it easy to match these male threads to BSP female fittings and components. Simple compatibility: fits standard 1/8 BSP and 1/4 BSP female ports without modification, reducing installation time and risk of misfit. Predictable sizing for system design: exact thread diameters (9.7 mm and 12.7 mm) allow accurate planning for hoses, adapters, and assemblies. Straightforward installation: male BSP threads are widely used and supported by common sealing methods (PTFE tape, joint compound, or compatible fittings). Function and compatibility Function: male BSP threaded connector intended to join with corresponding BSP female threads in fluid or gas systems. Compatibility: use with 1/8 BSP (DN6) and 1/4 BSP (DN8) female ports respectively. Confirm BSP thread standard on mating parts to ensure correct engagement. Size and performance notes Exact thread diameters provided for precise selection: 9.7 mm (1.01) and 12.7 mm (2.02). Performance depends on the mating components and system conditions (pressure, temperature, and medium). Select appropriate sealing method and confirm material compatibility for your application. Material Material is not specified here. Verify the product listing or supplier information for material type and suitability for your system (metal, brass, stainless steel, plastic, etc.) before use. Typical applications (practical scenarios) Pneumatic lines and equipment: connect pressure regulators, valves, or actuators that require 1/8 BSP or 1/4 BSP male connections. Instrumentation and low- to medium-pressure fluid systems: use in water, oil, or non-corrosive hydraulic lines where BSP fittings are standard. Plumbing and adapter assemblies: integrate into manifolds or hose assemblies to convert or extend BSP threaded connections. Installation tips Match BSP male to BSP female threads—do not mix BSP with NPT or other thread standards. Use an appropriate sealant (PTFE tape or thread compound) if required by the application and compatible with system media. Hand-start threads to avoid cross-threading, then tighten with appropriate tools to achieve a secure joint without over-torquing. Ordering reminder Select model 1.01 for 1/8 BSP (DN6) male, 9.7 mm diameter. Select model 2.02 for 1/4 BSP (DN8) male, 12.7 mm diameter. Confirm material and pressure/temperature ratings with the supplier if those attributes are critical for your application.