iCE40UP5k FPGA is used for core devices The 5280 unit (4-LUT+CARRY+FF) has the same FPGA resources as version and less resources than the Altera version; 120 Kbit dual port RAM 1 Mbit (128 KByte) single port RAM, which exceeds the internal memory capacity of the FPGA used by us, is the reason why it can support CNN; PLL, 2 x SPI, 2 x I2C hardened IPs. Two internal oscillators (10 kHz and 48 MHz) greatly the design. Eight DSP multiplier blocks are used for signal processing, such as voice synthesis and ; low power consumption for battery powered applications 3 x 24 mA drives and 3 x hard IP PWM (can directly drive RGB LED lights and small current motors) Enough, fast enough memory 128 Mbit (16 MB) SPI double data rate (QSPI-DDR) flash For example, video can be transmitted to LED A lot of I/O (actually, there are few pins of UP5K FPGA, they are enough) 3 pins for RGB LED 2 for board One UART port, pin and TX pin can be accessed through virtual USB serial port One key Two Pmod connectors ( 16x pins) There is a Pmod (8 x pins) that can be broken off shaped LED lights 3 keys Sufficient resources to support the CPU soft core picorv32 pico soc RISC-V and other soft cores On board FPGA programmer and USB to serial adapter Compatible with IceStorm iceprog tool Simple, no drive required to connect with the Pmod connector and Pmod module This board has three kinds of standard Pmod connectors, which can be expanded much - you can use many -made Pmod modules in the market, or you can design your own dedicated Pmod modules, for example, they developed seven segment digital tube Pmod, DIP switch Pmod, LED screen drivePmod and an -compatible output Pmod. Colour:blue Material:PCB+electronic components Package Contents: 1 x FPGA development board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.