P2040-1.14LCD is a high-performance Development board , Integrated 1.14 inch LCD (240x135 resolution, IPS screen, 65K RGB colors). with flexible digital interfaces. It incorporates s RP2040 microcontroller chip.The RP2040 features a dual-core ArmCortex-M0+ processor clocked at 133MHz with 264KB internal SRAM and 2MB internal flash storage.Inside the RP2040 is a permanent ROM USB UF2 bootloader. What that means is when you to new firmware, you can hold down the BOOTSEL button while plugging it into USB (or pulling down the RUN/Reset pin to ground) and it will appear as a USB disk drive you can drag the firmware onto.There is great C/C++ support, unofficial ( really good) for Arduinosupport, You can also use micropthon and circuitpython.Features:Lora module: With SX1262(803-930MHz,+22dBm)Size: 51.5 x 25 mmRP2040 32-bit M0+ dual core running at ~125 MHz @ 3.3Vlogic and power264 KB RAM2 MB SPI FLASH chip for storing files and CircuitPython/MicroPython code storage. No EEPROMFour 12 bit ADCs ( than Pico)Two I2C, Two SPI and two UART peripheralsIntegrated 1.14 inch LCDTwo buttons(IO0,IO1)Both Reset button and Bootloader select button for quick restarts (no unplugging-replugging to relaunch code)Integrated SD Card ConnectorPin 14 general blue LED flashing3.3V power indicator LEDBuilt in - charger with charging status indicator LEDOptional SWD debug port can be soldered in for debug access3.3V regulator with 500mA current outputUSB Type C connector lets you access built-in ROM USB bootloader and serial port debugging.Material: PCBcolour: pinkPackage Contents:1 x RP2040 Development BoardOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.