you can drive TFT LCD in a much faster speed using 84Mhz Ardiuno DUE. The shield is designed to fit two types of LCD: 1. 40pin version LCD which is commonly used in previous version of TFT shield for 2560 2. 32pin version LCD which is commonly used in STM32 development board. (unsoldered) The shield route all the LCD data pins to port PC1-PC8 and PC12-19, control pins to PD0-PD3, this design can acheive high speed data transfer (three cycles per write strobe to the LCD) to maximize LCD display speed. The SPI interface (for SD or flash control) is route to the ISP header of DUE, so that high speed SPI transfer with DMA can be achieved. The shield is compatible with DUE and the following LCD Colour: Black material: metal Overview: 3.2 inch TFT LCD Displayis a LCD Press screen module. It has 40pins interface and SD card and Flash reader design. It is a powerful and multifunctional module for your project. The Screen include a controller SSD1289, it's a support 8/16bit data interface , easy to drive by many MCU like STM32 ,AVR and 8051. It is designed with a Press controller in it . The Press IC is ADS7843 , and Press interface is included in the 40 pins breakout. It is the version of product only with Press screen and Press controller. Specification: 240374PQ 65K color 320*240 3.2 inch Wide viewing angle SSD1289:240 RGB x 320 TFT Driver Integrated Power, Gate and Source Driver With RAM ADS7843:4-WIRE TOUCH, UP TO 125kHz CONVERSION RATE, SERIAL INTERFACE Package Contents: 1* display 1* DUE module Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.