Mini mono 80*45mmsolar panel 5v 60ma for mini solar panel charging and generating electricity with mini solar lipo charger(Solar Panel) The product is shipped based on the color or size of the main image of the product page. ur:Solar panel Feture: Voltage:5V Current: 60MA Process: Epoxy Material: high rate solar cell epoxy resin AB glue, PCB or fiberglass backplane Size: 80*45mm Package include: 1*Solar panel Solar Charger a supper mini Solar Lipo charger based on the CN3065 - a single lithium charge management chip. Solar charger provide you with the ability to get the most possible power out of your solar panel or photovoltaic device and into a rechargable LiPo . Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your into the and you are good to start charging The output of the Solar Charger is intended to charge a single pol lithium ion cell. The load should be connected in parallel with the . By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). Its recommended that batteries not be charged at greater than their capacity rating : Solar panel input: 4.4-6V Max charge current: 500Ma Interface: 2-pin JST connectors(or PH2.0) Short circuit protection Continuous Charge Current 500mA status indication ( Red : Charging , : Charged ) Micro-USB Connector Package A Include Solar panel *1 Solar charger *1 cable *3 Package B Include All set Package Include ( not include ) 1* Solar Panel 1*1S display 1* Solar charger 1* 1S Holder 2* CH2 Connector 3* Cable