This MSP -FET430UIF is a powerful flash emulation tool to started with application development quickly on the MSP430 MCU. It includes USB debugging interface used to & debug the MSP430 in-system via the JTAG interface or the pin saving Bi-Wire (2-wire JTAG) protocol. The flash memory can be erased and reprogrammed in seconds with only a few keystrokes. The MSP430 flash is ultra-low power, so no external power supply is required. This debugging tool interfaces the MSP430 to the included integrated software environment and includes code to immediately. The MSP -FET430UIF development tools supports development with all MSP430 flash devices. The USB Debugging Interface is compatible with IAR Version 3.21 or higher. Via USB debugging interface (MSP-FET430UIF), a flash-based MSP430 MCU can be connected to a PC for real-time, in-system programming and debugging : it can support Windows XP, Windows Vista, Windows 7 (32 & 64-bit) Technical Specifications: Software configurable supply voltage: between 1.8 and 3.6 volts at 100mA Supports JTAG Security Fuse blow to protect code Supports all MSP430 boards with JTAG header Supports both JTAG and -Bi-Wire (2-wire JTAG) debug protocols : plastic colour: As shown Package Contents: 1 x MSP 430 debugger 1 x USB cable 1 x 14-pin Flat cable 1 x CD Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.