1、Excellent Stainless Steel: The sensor beam is made of stainless steel, IP65 protection grade, low drift, tight structure, light weight, high accuracy, quick response time, long service life, and strong anti interference ability. 2、High Accuracy: This sensor uses a high accuracy anti deflection load mid air chip, and the register is more accurate. 3、Small Size: The small size and light weight of this sensor makes it very convenient to install in a relatively small space. 4、Simple Installation: This sensor is very easy to install, you just need to follow the instructions to connect the wire and you are done, no other professional operation is required. 5、Wide Application: This sensor is suitable for force measurement and control in 3C digital production process, automation equipment, aging testers, key force analysis, and booster devices. Item Type: Miniature Load Cell Model: DYHW 116 Output Sensitivity: 1-2mV/V based on production test data Zero Output: ±1%F.S. Non Linearity: 0.3%F.S. Hysteresis: 0.3%F.S. Repeatability: 0.3%F.S. Creep (30 Min): 0.1%F.S. Temperature Sensitivity Drift: 0.3% F.S./10°C Zero Temperature Drift: 0.3%F.S./10℃ Response Frequency: 1kHz Material: Stainless Steel Impedance: 700/1000Ω Insulation Resistance: ≥5000MΩ,100VDC Use Voltage: 5V-10V Operating Temperature Range: Approx. -20-80℃ / -4-176℉ Safety Overload: 150% Limit Overload: 200% Cable Wire Specification: Dia 3x2m Cable Ultimate Pull: 98N 1 x Miniature Load Cell