Features: The module supports high-level trigger, low-level trigger, switch control, PWM control Trigger signal source: high level trigger (DC3.0V-24V), low level trigger (DC 0.0V-0.6V), switch value control, can be connected to MCU IO port, PLC interface, DC power supply, etc;Can be connected to PWM signal, signal frequency 0-2.5KHZ perfect support. Output capacity: DC 4V-40V, continuous current 10A at room temperature, power 400W! Under the condition- of auxiliary heat dissipation, the current can reach 15A. Application: The output end can control high-power equipment, motor, light bulb, LED light band-, DC motor, micro water pump, solenoid valve, etc., and can input PWM to control motor speed, light brightness, etc. Service life: unlimited switching; Working temperature: -40-85 Specifications: Working voltage: DC 4V-60V High Level Trigger DC3.0V-24V; Low Level Trigger DC 0.0V-0.6V Size:approx 48x34mm/1.89x1.34in Output Capacity: DC 4V-40V, C Continuous current 10A Power 400W Note: 1. Only one signal can control the module at the same time, and two or more signals cannot be used to control the module at the same time; 2. High-level trigger voltage range: DC3.0V~24V, that is, when the signal is 3.0V~24V, the MOS tube is on, lower than 0.6V, that is, 0V~0.6V, the MOS tube is off, and the signal voltage must not be between 0.6V and 3.0V, so that the MOS is not fully open, and the MOS is burned by high-power use; 3. Low level trigger voltage range: DC 0V~0.6V, that is, when the signal voltage is 0V~0.6V, the MOS tube is on, when the signal voltage is higher than 3.0V, the MOS tube is off, and the signal voltage must not be between 0.6V and 3.0V, so the MOS is not fully open, and the MOS will be burned by high-power use. Package includes: 1PC MOS Trigger Switch Drive Module