Bezel Control Switch, Blinker Trim Control System Single Function - Engine Trim/Jack Plate Fit for Seastar Hydraulic, Cable and Tilt Steering, Replace PT1000-1P, PT1000-2P GREAT APPLICATION -- Fits for Hydraulic, Cable, and Tilt Steering, also suitable for most mechanical steering systems, such as most Dometic/SeaStar Solutions steering systems. Compatible with Safe-T mechanical steering, Rack & Pinion mechanical steering, NFB No FeedBack steering (all helms), SeaStar hydraulic steering, SeaStar PRO hydraulic steering, Command 200 Rack & Pinion, Tilt steering. EXCELLENT FUNCTION -- Single function switches is the ultimate combination of design, function and value for Hydraulic Helms. Not only to tilt and trim systems, can also be used to control hydraulic jack plates or horn at the wheel. Convenient to the boat driver to keep both hands on the steering wheel for a more safe control. Also very handy that when you adjust your jack plate up or down. EASY INSTALLATION -- This unit can be added to any boat by anyone, allows to install on the right or left side of the bezel or both for dual controls. Easy to install, can finish this job in minutes without remove your steering wheel! Only wrap the locking collar around your bezel and attach two nuts and bolts, Then run the attached wire through the dash and connect into trim system wiring harness. SUPERIOR MATERIAL -- These bolt-on controls are made with a stainless steel bracket and UV-stabilized ABS switch covers with Mylar function decals. The heavy-duty marine wiring harness is color coded to match existing trim and jackplate wiring. Which resists Oxidation, wear, anti-seawater corrosion and solvents, sturdy and durable. High standard precision and professionalism to provide a much longer service life. SATISFACTION GUARANTEE -- We aim to give our customers the best products and services. If you're not 100% satisfied with this PT1000-1P Pro Trim/Jack Plate Control Single Switch, simply return it for a full refund in 30 days. Support 12 months warranty.