Holybro Remote ID Module Compatible WIFI / bluetooth Support PX4 / Ardupilot CAN / Serial Protocol For RC Model UAVs Drone Airplane -Overview: Holybro RemoteID Module is a lowcost, smallsize, and lightweight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CEapproved radio module. The products run opensource firmware (ArduRemoteID) and provides a socalled standard Remote ID solution, primarily target drone manufacturers & system integrators. -Note: This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, as you need to do your own approval process at the FAA (DoC submission) if you are in the USA. For the most accurate and latest information related to this topic, please refer to the official governance website of your country. -Specification: • Radio module: Espressif ESPC3 module Bluetooth and WiFi 2.4GHz (ERP): 20 dBm (100 mW) -FCC & CE certified radio module • Firmware: ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID). Supports upgrading firmware via the web interface ("OTA") • Supported in PX4 & Ardupilot • Protocol: CAN & Serial • Interface: 1x JST GH 4pin CAN (CAN) port 1x JST GH 6pin TELEM (UART) port • Antenna Connector type: On CNC Case: SMA connector On PCB: IPEX Connector • Range: > 5km detection range* • Power: 5V supplied from TELEM or CAN port • LED lights: Bright RGB status LED • Size: Without case: 35.3 x 23.5 mm (not including antenna) With CNC case: 38 x 26.5 x 11.5 mm (not including antenna) • Mount: M2 screws • Operating temperature: 40°C to +85°C • Weight: PCB only: 4 g With CNC case & Antenna: 27.5g Without case & Antenna: 16.5g (Cable 20cm) • Certification: FCC & CE * The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height line of sight etc. With professional receivers a range of 5 km and more is possible. -Package Includes: 1x Remote ID 1x Antenna 1x JST GH 6pin 150mm Cable 1x JST GH 4pin 150mm Cable