controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, for AirSpeed Linear Regulator Voltage adjustable, 5V Default, 6V or 7.2V via jumper Continuous current 2 Amps, 3A MCU: STM32H743VIT6, 480MHz , 1MB RAM, 2MB Flash IMU: ICM42688-P(V3) & ICM42605 (SPI4) Baro: DPS310 (I2C2) OSD: AT7456E (SPI2) : Micro-SD card slot (SDIO) 7x Uarts (1,2,3,4,6,7,8) with built-in inversion. 13x PWM outputs(including "LED" pad) 2x 1x CAN 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, VB2, CU2) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red) USB/Beep Extender with Type-C(USB2.0) Dual Camera Inputs switch 5V/9V(12V) for Camera/VTX power switch High- Current Sense (90A continuous, 220A ) Battery Voltage Sensor: 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ) ADC VB2 voltage divider: 1K:20K ADC AirSpeed voltage divider: 20K:20K Static power 160mA 5V for (ChiBiOS): MATEKH743 for INAV: MATEKH743 Input voltage range: 8-36V (3-8S LiPo) with protection The product appearance and printed words depending on the batch, but this does not affect use Colour:As Shown Material:PCB Package Contents: 1set x flight controller accessories Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.