PWM Speed Controller designed for 12V 4-wire PWM fan or pump. This PWM Speed controller support 12v standard fan speed control, also support computer water cooling PWM pump speed adjustment. This governor is recommended to control the output power within 7-8 watts (12V 0.6A). This governor input port is USB Type-C female.Output is standard PWM 4pin fan port. Built-in DCDC boost circuit(boost USB 5V to 12V).Built-in pwm signal generator ( to adjust speed). Fan speed adjustment range 0-100 percent . Turn the knob clockwise to increase the speed, Turn the knob counterclockwise to reduce the speed. The application scenario of the governor design is mainly powered by the charging or rechargeable battery, the common output capacity is generally 5V or 2A, higher specifications are relatively rare, and the parameters of 12v or 0.7A fan almost reach 5V or 2A full power supply, while taking into account the small size of the PWM governor so limited cooling capacity. It is recommended that the output current be controlled below 0.7A for short time use and below 0.5A for long time use. Here means the current at the maximum speed, the fan current vary proportionally according to the speed. Input voltage: 5V Output voltage: 12V PWM frequency: about 25KHz Output current: rated 0.5A or maximum 0.7A Input port: USB TYPE-C female port Output: PWM 4Pin Speed range: PWM duty cycle 0-100 percent type: 1 to 2 Adapter cable Colour:Black Material:plastic Package Contents: 1 x PWM Speed Controller 1 x USB to TYPE-C power supply cable 1 x Adapter cable Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is 1-3cm. Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.