1Single channel USB to serial / parallel ports with a variety of configurations. 2Whole USB protocol handled on the chip, no USB specific firmware programming required. 3USB 2.0 high-speed (480Mbits/Second) and full speed (12Mbits/Second) compatible. 4Multi-protocol synchronous serial engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design. 5UART data transfer rate up to 12Mbaud (RS232 data rate is limited by external level shifter). 6USB to synchronous 245 parallel FIFO mode transfer up to 40 megabytes/second. 7USB to asynchronous 245 fifo mode data transfer rate up to 8 megabytes per second. 8Support for special half-duplex FT1248 interface with configurable width, bidirectional data bus (1, 2, 4 or 8 bit wide). 9CPU - style FIFO interface mode simplifies CPU interface design. 10Fast serial interface option. 11FTDIs royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases. 12Adjustable receive buffer timeout. Condition: 100% Brand NewItem Type: USB to JTAG UART/FIFO SPI/I2C ModuleTypical ApplicationsSingle chip USB to UART (RS232, RS422 or RS485)USB to FIFOUSB to FT1248USB to JTAGUSB to SPIUSB to I2CUSB to Bit-BangUSB to Fast Serial InterfaceUSB to CPU target interface (as memory) 1 x Module3 x Pin Header