OBD2 Diagnostic Connector Cable USB Interface Auto Fault Checking Tool Fit for Ford Item Type: OBD2 Diagnostic Connector Cable Material: Plastic Technical Details: 1. Latest version greater Fit for Ford compatibility 2. Manufactured modification to include a switch to connect to different CAN buses 3. Designed for FORScan software 4. Compatible with software venders; For FORScan / Elmconfig / FF2 / FoCCCus, plus more 5. MS CAN bus and HS CAN bus support 6. Drivers and instructions included Product Introduction: OBD2 scanners. This includes showing you trouble codes, PIDs, running tests and services procedures which are never displayed by other OBD2 scanners and a standard diagnostic cable. Basic Features: Reset fault /trouble codes / parameter ids (PIDs) Change car configuration data Run tests Services procedures Program certain models Pin Configurations: Switch Position One: HS CAN - Occupies pins 6 and 14 Switch Position Two: MS CAN - Occupies pins 3 and 11 Supported Software: For FORScan For Elmconfig For FoCCCus For FF2 Plus more Modified EML: Please note that many for Ford and for Mazda models (approximately since 2003-2004) are equipped with MS CAN bus, in addition to the regular HS CAN bus. In contrast to HS CAN bus, MS CAN bus is not supported by the stock , because MS CANis a manufacturer-specific solution and located on non-OBD2 pins. This has been modified to allow it to implement the MS CAN bus. Supports HS CAN from the stock, because for Ford HS CAN completely matches to the OBD2 standards. It occupies pins 6 and 14. MS CAN bus occupies pins 3 and 11. Fitment: Fit for Ford that can be addressed using an ELM via an OBDII connector. Fit for Mazda that can be addressed using an ELM via an OBDII connector. Fit for Lincoln that can be addressed using an ELM via an OBDII connector. Supported Protocols: Fit for FORD HS CAN Fit for FORD MS CAN