<p>This is a gamepad firmware for the for Pico and other boards based on the RP2040 microcontroller, and provides high performance with a rich feature set across multiple platforms. It is compatible with PC, for MiSTer, for Android, for , for , for PS3 and for .</p> <p>Features:Selectable input modes (XInput, DirectInput and )</p> <p>Overclocked polling rate to 1000 Hz (1 ms) in all modes, with less than 1ms of input latency</p> <p>Multiple SOCD cleaning modes - Neutral, Up Priority (a.k.a. ), Second</p> <p>Input Priority:Left and Right stick emulation via D-pad inputs</p> <p>Per-button RGB LED support</p> <p>PWM and RGB player indicator LED support (XInput only)</p> <p>Saves to internal memory</p> <p>Support for 128x64 monochrome I2C displays using , SH1106 or SH1107 display drivers.</p> <p>Built-in configuration app hosted via embedded webserver...no downloading a separate app!</p> <p>Performance:Input latency is tested using the methodology outlined at WydD's inputlag.science website, using the default 1000 Hz (1 ms) polling rate in the firmware.</p> <p>Input Modes:</p> <p>To change the input mode, hold one of the following buttons as the controller is plugged in:</p> <p>A for </p> <p>B for XInput</p> <p>X for DirectInput\/PS3</p> <p>Y for </p> <p>Input mode is saved across power cycles.</p> <p>D-Pad Modes:</p> <p>You can switch between the 3 modes for the D-Pad while the controller is in use by pressing one of the following combinations:</p> <p>SELECT + START + DOWN - D-Pad</p> <p>SELECT + START + LEFT - Emulate Left Analog stick</p> <p>SELECT + START + RIGHT - Emulate Right Analog stick</p> <p>D-Pad mode is saved across power cycles.</p> <p>size: 29.5 x 19.5cm</p> <p>color: White</p> <p>Material: acrylic + metal + electronic components</p> <p>Package Contents:</p> <p>1 x gaming keyboard</p> <p>1 x data cable</p> <p>Only the above package content, other products are not included.</p> <p>Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.</p>