Product Introduction: MKS CAN V2.0 module is an upgraded version of MKS CAN V1.0. CAN 2.0 is a small, low-cost, open-source USB to CAN analyzer. CAN enumerates as a virtual serial port on your computer and acts as a serial line for the CAN bus interface. CAN 2.0 supports standard CAN 2.0A, CAN 2.0B protocols. When using the candleLight firmware, CAN is enumerated as a native CAN interface on Linux. The CAN analyzer is compatible with ARM-based embedded platforms, such as Raspberry Pi, Raspberry Pi Zero, ODROID, BeagleBone, etc., making it suitable for integration into products. Product Features: 1. Supports CAN 2.0A, CAN 2.0B, baud rate up to 1M; 2. Supports candleLight, slcan firmware; slcan supports CAN FD with test rates up to 2M/5M baud rate; 3. Terminal resistor can be selectively enabled or disabled via jumper; 4. Supports Type-C USB interface, online firmware upgrade, and DFU mode firmware upgrade; 5. Uses high-performance ARM-M4 STM32G431C8T6 processor, operating frequency up to 170MHz; 6. Provides schematic diagram, firmware, source code, and host software; complete information for easy use. Analyzer Board Version: V2.0 Material: ABS Color: As shown Package Contents: 1 x USB data cable 1 x 3-pin double cable 1 x Analyzer board Note: Light reflection and different displays may cause the color of the item in the picture to differ slightly from the actual product. Measurement error allowance is +/- 1-3 cm.