90° Angled DualDeck SATA 6Gb/s 7Pin Female to 7Pin Male Adapter for Desktop Motherboards A compact rightangle adapter that changes the orientation of a standard 7pin SATA connection while preserving SATA III performance. The dualdeck (stacked) female connector and single 7pin male plug make it easy to route SATA cables in tight spaces behind drive cages or motherboards without bending cables or stressing connectors. Key benefits Saves space and reduces cable strain: 90° orientation keeps cables close to the PCB and reduces pressure on connectors in cramped desktop builds. Maintains performance: Designed for SATA III (6 Gb/s) interfaces so you keep full transfer rates when used with compatible drives and controllers. Straightforward, reliable adaptation: Converts between standard 7pin male motherboard headers and stacked 7pin female SATA cable connectors for easier cable routing and connection. Key attributes Functionality: Rightangle adapter that provides two stacked (dualdeck) 7pin female SATA ports mated to a single 7pin male SATA plug. Compatibility: Works with standard 7pin SATA cables, SATA drives, and desktop motherboard SATA headers that support SATA I/II/III (up to 6 Gb/s). Size and form factor: Lowprofile, 90° angled design suited for tight or shallow case layouts and behind drive bays. Construction and reliability: Built for typical desktop environment use with secure mechanical fit between connectors. Performance: Supports SATA interface speeds up to 6 Gb/s when used with SATA IIIcapable devices and controllers. Use cases Tight motherboard locations: Reorient a SATA cable when the motherboard SATA header is perpendicular to available cable routing space, preventing sharp bends and connector strain. Behind drive cages and trays: Connect and route SATA cables neatly when drive bays leave little clearance for straight connectors. Cable orientation fix: If a preinstalled SATA cable or drive connector is obstructing other components, use the adapter to change the plug direction without replacing cables. Important note This adapter changes connector orientation and provides dual stacked female ports for physical cable connections. It does not split a single SATA host port into two independent host connections. Each SATA host port supports only one device unless used with a dedicated SATA controller or hardware port multiplier. Installation Plug the 7pin male end into the motherboard SATA header. Connect your SATA cable(s) to the stacked 7pin female port(s). Ensure connectors are fully seated and avoid excessive force when routing cables. Compatibility summary Interface: SATA 7pin Speed: Up to SATA III / 6 Gb/s Intended use: Desktop motherboards and SATA cables/connectors The 90° Angled DualDeck SATA adapter is a practical solution for improving cable management and connector orientation in desktop PC builds while preserving standard SATA III performance.