For Immobiliser Emulator 2002 - 2021 R1 R6 MT07 MT09 MT10 TMAX XMAX++ Compatible 2002 - 2021 For models: ✔ YZF R1 / YZF R6 ✔ FZ6N / FZ6S ✔ XJ6 ✔ T-MAX ✔ X-MAX ✔ V-MAX ✔ MT03, MT07, MT09, MT10 ✔ MAJESTY 400 ✔ XSR700 ✔ XSR900 This new version has been redesigned with the following features: Mechelectrics Custom Firmware – Exclusive firmware allows compatibility with a wide range of models Reduced Power Consumption – Lower current draw from battery in standby mode Higher Rated Capacitors – Improved reliability and durability compared to older designs Dual Layered PCB – Enhanced resistance to corrosion in damp or wet conditions Compact Design – Minimal wiring for clean installation 30% Smaller PCB – Reduced size and weight compared to previous versions Water Resistant Casing – Sealed unit prevents water ingress This device is designed for the following purposes: - Engine swaps where the original immobiliser unit is not compatible with the replacement ECU - Removal of damaged immobiliser units due to theft or recovery damage - Avoiding high replacement costs associated with matched immobiliser and ECU units - Use in project bikes with engines and ECUs that do not include an immobiliser system - Diagnostic troubleshooting by eliminating the immobiliser as a potential cause of starting issues The 6-wire version offers maximum compatibility by utilizing the full manufacturer wiring schematic, maintaining immobiliser dashboard LED functionality where applicable. Custom firmware is programmed in-house to ensure broad model compatibility. If this emulator is not compatible with your listed model, return for a full refund. Fitting Instructions: 1) Trace the wiring from the key barrel transponder to the ECU, typically located under the fuel tank or near the headlight assembly. 2) Disconnect the original connector and install the plug-and-play emulator. 3) The vehicle can now be started without a transponder in the key.