Reliable material: Our FEP film sheet is heat resistant up to 204 degrees Celsius, featuring a non-stick, smooth, and non-scratch surface. It is UV stable and designed for long-term durability. Wide compatibility: These 3D printer films are compatible with Photon, Wanhao UV, Mini Deluxe SLA, Mars LCD, and other 3D printers with the same size frame, meeting a variety of user needs. Performance: The 3D FEP film sheet offers high transmittance, strength, and UV resistance. It maintains clarity and withstands the sustained high temperatures generated by UV SLA 3D printers, allowing over 95 percent of UV light to pass through without interference. Well protected: Both sides of the 3D printer FEP films are covered with a protective layer. Remove the protective film before use. Regularly replacing the plastic spatula helps prevent damage to the FEP film when installed at the bottom of the resin vat. Avoid using metal spatulas or tools on the film. Easy to install: 1. Remove the screws to detach the steel rings from the resin vat. 2. Remove the remaining screws to separate the steel ring and replace the film. 3. Place the new FEP film between the steel rings and reinstall the screws, ensuring they are tightly secured. 4. Reattach the steel rings to the resin vat, making sure the FEP film is clean and properly tensioned. Specifications: Color: Transparent + yellow Material: FEP + plastic Size: 200 x 140 x 0.15 mm Thickness: approximately 0.15 - 0.2 mm Package Contents: 12 x FEP films 2 x Plastic spatulas Note: Only the items listed above are included. Other products are not included. Note: Lighting and display differences may cause slight variations in the color of the item shown in the picture compared to the actual product. Measurement may vary by +/- 1-3 cm.